<p id="pt5xf"></p>

            <p id="pt5xf"></p>

                <em id="pt5xf"></em>

                <listing id="pt5xf"><delect id="pt5xf"></delect></listing>
                  <em id="pt5xf"></em>
                <form id="pt5xf"></form>
                <pre id="pt5xf"></pre>

                WELCOME TO WUXI CITY HUIFENG ELECTRONIC.CO.LTD!
                National Consultative Hotline 0510-85310683

                PRODUCT CENTER

                Contact US

                Address:No.20 16-3 plot,5th,Shuofang Industrial Concentrated Zone, New District, Wuxi 214142, Jiangsu, P.R.China
                TEL:0510-85310683
                Website:www.gomamatoday.com
                Fax:0510-85310683
                Mailbox:tdh@hfpzt.com
                   wxhfscb@163.com

                Attention point of piezoceramic welding

                publish:HUIFENG  time:2017年06month09day

                What is the vibration detection circuit of a piezoelectric ceramic chip? What should be paid attention to in the process of welding? In addition, what is the relationship between the waveform and time of electricity generated by piezoelectric ceramics and the force? Now that these problems have been raised, the following, to solve it immediately, I hope you can get some new harvest and inspiration.
                1. what is the vibration detection circuit of the piezoelectric ceramic chip?
                The vibration detection circuit of piezoelectric ceramic chip is not complicated. It only needs to connect two electrodes to the oscilloscope. However, it should be noted that the voltage at both ends of the ceramic sheet is MV grade. Moreover, if the amplitude of the signal is too low, the low noise operational amplifier can be used to amplify the signal for observation.
                2. what should we pay attention to during the welding process of piezoelectric ceramics?
                There are some points for attention in the welding of piezoelectric ceramics.
                The welding temperature should not be too high; in the welding time, it is not suitable for the process, otherwise, it will affect the quality of the welding, and then affect the use effect of the piezoelectric ceramic. In general, it takes only a few seconds to weld.
                3., what is the relationship between the waveform and time of electricity generated by piezoelectric ceramics and the force?
                In particular, if it is a periodic changing force that continues to act on a piezoelectric ceramic piece, then the piezoelectric ceramic will continue to generate electricity, and its waveform is closer to the sine wave. If it is a momentary force, then the wave is approaching the pulse.
                The above problems are all from the web product of the piezo ceramic piece, which are extended, and it is not before, so I hope you can take it seriously and carry on it so that you can understand and master it in time. In this way, even in practice, we can deal with it calmly and solve it satisfactorily, so as to avoid unnecessary problems or troubles.

                          <p id="pt5xf"></p>

                          <p id="pt5xf"></p>

                              <em id="pt5xf"></em>

                              <listing id="pt5xf"><delect id="pt5xf"></delect></listing>
                                <em id="pt5xf"></em>
                              <form id="pt5xf"></form>
                              <pre id="pt5xf"></pre>

                              麻豆国产av穿旗袍强迫女佣人_第一次摘花疼痛哭叫视频_777奇米影视_gogo西西人体大尺寸大胆高清